A new customer in Bridgewater, NJ, called our office after finding a massive amount of mold in her attic! Once we arrived and equipped our Personal Protective Equipment, we inspected the attic and, low and behold, we found mold all over almost every single rafter. Turns out, there was a leak in the roof! Roof leaks may not be noticed until the leak progresses enough to damage the top floor's ceiling, and by that point, the attic's mold growth could be extensive. Fortunately, the leak wasn't too bad and the homeowner knew a roofer who would come out once we finished our treatment process. 

First, we treated every square inch of the attic with MAPS 1, which is an EPA registered antimicrobial. MAPS 1 attacks mold at its DNA and kills it immediately. Using our mold stain remover, we removed all the mold stains and applied MAPS 2, which is our patented sealant. MAPS 2 encapsulates the surface mold is growing on and renders it harmless, inert, and non-allergic. MAPS 2 also reactivates whenever it gets wet to prevent any future mold growth. 

After noticing mold growing on several areas in his crawl space, this customer in Gladstone, NJ called our office for an inspection and treatment. When we arrived and started inspecting the area, not only did we find mold on several joists, but almost every single piece of insulation was contaminated with mold! What caused the mold growth? High humidity levels in the crawl space!

First, we removed and disposed of all the contaminated insulation and then treated the entire crawl space with our EPA registered antimicrobial called MAPS 1. This solution targets mold at its DNA and immediately kills it. Afterward, we applied our mold stain remover and scrubbed away all the mold stains. Next, we treated the crawl space with MAPS 2, which is our patented sealant that encapsulates the surface mold is growing on and renders it harmless and non-allergic. MAPS 2 is also moisture sensitive and will reactivate whenever it gets wet to prevent any future mold growth.

Next, we installed ComfortTherm® insulation. ComfortTherm® insulation provides excellent temperature and noise control, and comes with a vapor-retarder for use in hot, humid climates. Lastly, we installed a Sani-Dry Sedona commercial-grade dehumidifier. The Sedona directs the extracted water pulled out of the air directly into the sump pump and will control the humidity levels in the crawl space.

This customer in Bridgewater, NJ had to stop the selling process of her home because the home inspector found mold in the attic. The homeowner saw us encapsulate the crawl space at her neighbors house and knew that we remove mold from homes, so she gave our office a call and we were sent out!  As we inspected the attic, we were told that there was a leak in the attic a short while ago that was professionally repaired by a roofer. That leak went unnoticed for a while and, although it was repaired, mold still developed and no one noticed, since the owner hasn't been in attic since the repair.

First, we applied our EPA registered antimicrobial called Mold Abatement Polymer Solutions, or MAPS 1 for short. This application attacks mold at its DNA and immediately kills it. Next, we applied our mold stain remover and scrubbed away any and all mold stains. Lastly, we treated the attic with our patented sealant called MAPS 2. This encapsulates the surface mold is growing on and renders it harmless and non-allergic. MAPS 2 is also moisture sensitive and will reactivate whenever it gets wet to prevent any future mold growth. 

Now the mold is gone and the homeowner can continue with the real estate sale of her home!

After our Pest Control Division had removed all the mice from the crawl space of this home in Neshanic Station, NJ, we were sent our to eliminate the massive amount of mold growth throughout the area. There was an extremely high level of moisture in the crawl space because of the dirt floor. Soil and dirt from the earth contain moisture and since moisture forms so easily in confined areas, dirt crawl spaces are fertile breeding grounds for mold! The homeowner didn't even bother checking in his crawl space for weeks, which was plenty of time for the mold to grow.

First, we applied our EPA-registered antimicrobial called MAPS 1. MAPS stands for Mold Abatement Polymer solutions and targets mold at its DNA and immediately kills it! We then used our mold stain remover, scrubbed away all the excess mold staining throughout the joists, and applied MAPS 2. MAPS 2 is our patented sealant that encapsulates the surface mold is growing on and renders it inert, harmless, and non-allergenic. It's also moisture-sensitive and will reactivate whenever it gets wet to prevent future mold growth. 

Lastly, we installed a Sani-Dry Sedona commercial grade dehumidifier in the crawl space. These dehumidifiers cost less to run than other dehumidifiers, cover over 3000 square feet, and are energy efficient.

We were sent out to the home of a new customer in South Bound Brook, NJ, to treat for mold in the crawl space. A previous inspection revealed that mold was growing all over the cement walls of the crawl space. If the conditions are right, mold can grow on cement and concrete surfaces. Since concrete is porous, it can hold water and provide the nutrients needed for mold growth. Continuing our inspection, we determined that the humidity levels in the crawl space were extremely high.

First, we treated the entire crawl space with an antimicrobial called Mold Abatement Polymer Solutions, or MAPS 1 for short. MAPS 1 attacks mold at its DNA and kills it immediately. Once that was completed, we applied our mold stain remover and scrubbed away all the mold stains.

Afterward, we applied our patented sealant called MAPS 2. MAPS 2 encapsulates the surface mold is growing on and renders it harmless and non-allergic and will reactivate whenever it gets wet to prevent any future mold growth. Lastly, to resolve the high humidity levels in the crawl space, we installed a Sedona Sandi-Dry XP dehumidifier. A Sedona Sandi-Dry XP is a powerful, energy-efficient dehumidifier that outperforms standard household dehumidifiers by as much as 10 times while using the same amount of energy to run.